Extend the life of your ID cards with EDIsecure DIC10507 Lamination (or overlamination). Lamination provides a thin layer of protection to increase resistance to fading and wear, reducing your need to reprint ID cards.

EDIsecure DIC10507 laminate is for laminating a card's magnetic stripe side. Half-panel laminate provides maximum coverage and card protection while leaving the magnetic stripe exposed.

To use the EDIsecure DIC10507 overlamination you will need a printer with lamination capability.

To ensure the best performance from your EDIsecure ID printer, EDIsecure recommends using genuine EDIsecure supplies.

Manufacturer and item#: EDIsecure DIC10507

• Clear Half Patch Laminate
• 0.5 mil thickness
• For the lamination of cards after printing in re-transfer printers

550 imprints per roll

• *For use with the following EDIsecure lamination modules:
  • ILU Inline Lamination Unit
  • ILM Inline Lamination Module
  • ILM-LS Inline Lamination Module (Lower Side)

ILM-DS Inline Lamination Module (Dual Side)

• *For use with the following EDIsecure printers with lamination:
  • XID560ie
  • XID570ie
  • XID580ie
  • XID590ie
  • XID9300
  • XID9330
  • DCP360+
  • XID8300

**Note: If performing inline mag encoding in any XID printer, this will not work with the ILM-LS or the lower cassete of an ILM-DS.